With ARGUS we have a powerful software tool to do all the calculations mentioned below after forming a blank that has been prepared with a point raster before:
According to the results we can now optimize the forming process and get the maximum out of the parts.
With ATOS III parts can be scanned and measured in three dimensions. The result of the measurement is a virtual 3D model, which can be compared to the reference model from the CAD data. The monitoring of the real product geometry is very important to achieve a high and constant level of quality and small tolerances.
Institute of Materials Science, Joining and Forming Research Group Tools & Forming Inffeldgasse 11/I 8010 Graz
Tel.: +43 (0) 316 / 873 - 9441 Fax: +43 (0) 316 / 873 - 9442 office.tfnoSpam@TUGraz.at